40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  SUS Lab eLog  Not logged in ELOG logo
Message ID: 198     Entry time: Tue May 10 18:29:44 2011
Author: Mingyuan, Tara 
Type: DailyProgress 
Category: Creak 
Subject: Solid work drawing 

We measured the tip tilt angle of the blade while the main part of blades was bent flat.  REM: ~9 degree; ROM: ~ 7 degree. This angle should be able to cancel by mirror holder.

One block of Al was designed to mount mirror holder with the blades. The SolidWork drawing is attached below.

Two screws (2-56, A2, 3/16) will be used to mount the block onto blades through the two holes in the head of blades.

One screw (8-32) will be used to mount the mirror holder onto the block. The mirror hold is light, the block should be able to hold it firmly.

The other drawings will be uploaded by Tara

Attachment 1: Mirrormount.PDF  54 kB  | Hide | Hide all
Mirrormount.PDF
Attachment 2: clamp_of_the_blade.pdf  59 kB  | Hide | Hide all
clamp_of_the_blade.pdf
ELOG V3.1.3-