40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  SUS Lab eLog  Not logged in ELOG logo
Message ID: 1885     Entry time: Wed Dec 30 09:57:56 2020
Author: Paco 
Type: DailyProgress 
Category: Optics 
Subject: DOPO crystal oven 

Assembled first DOPO oven with the crystal. The components (shown below) are:

  • Oven clip
  • Oven
  • ITO crystal spacer
  • PPKTP crystal

The NL crystal sits in the (brass?) clip directly, with the ITO (dummy) crystal pressing it uniformly down. There are no placement references to align the crystal with the oven axis, so this was done very carefully by hand. Once this is roughly straight, the copper arms are fastened in place tight enough to hold everything in place but without excess strain on the NL crystal. The assembly (shown below) is then mounted enclosed in the oven. I put some kapton in place to shield from dust until operation.

Attachment 1: ppktp2.jpg  1.936 MB  | Hide | Hide all
Attachment 2: ppktp1.jpg  1.805 MB  | Hide | Hide all
ELOG V3.1.3-