|
40m
QIL
Cryo_Lab
CTN
SUS_Lab
CAML
OMC_Lab
CRIME_Lab
FEA
ENG_Labs
OptContFac
Mariner
WBEEShop
|
| Mariner elog |
Not logged in |
 |
|
|
|
|
|
Message ID: 41
Entry time: Thu Oct 14 04:17:36 2021
In reply to: 40
|
| Author: |
Jiri Smetana |
| Type: |
General |
| Category: |
General |
| Subject: |
Damping Loop (Point-Mass Pendulums) |
|
|
Here are the DAC and residual displacement spectra for different suspension heights ranging from 450 mm to 600 mm. I aimed to get the Q of the lower resonance close to 5 and the DAC output RMS close to 0.5 V but as this was just tweaking values by hand I didn't get to exactly these values so I'm adding the actual values for reference. The parameters are as follows:
| Height [mm] |
Displacement RMS [nm] |
DAC Output RMS [V] |
Q Lower Resonance |
Q Higher Resonance |
Driver Resistor {Ohm] |
| 600 |
560 |
0.51 |
5.3 |
1.5 |
175 |
| 550 |
580 |
0.54 |
5.1 |
1.4 |
175 |
| 500 |
610 |
0.49 |
5.0 |
1.4 |
150 |
| 450 |
630 |
0.54 |
5.0 |
1.4 |
150 |
| Quote: |
|
Now that I have correct phase and amplitude behaviour for my MIMO state space model of the suspension and the system is being correctly evaluated as stable, I'm uploading the useful plots from my analysis. File names should be fairly self-explanatory. The noise plots are for a total height of 550 mm, or wire lengths of 100 mm per stage. I've also attached a model showing the ground motion for different lengths of the suspension.
|
|
|
|
|
|
|
|
|
|
|
|