I increased the sampling rate for the channels

• X1:CRY-BEAT_MON_OUT_DQ
• X1:CRY-E_TRANS_OUT_DQ
• X1:CRY-W_TRANS_OUT_DQ
• X1:CRY-E_ERROR_OUT_DQ
• X1:CRY-W_ERROR_OUT_DQ
• X1:CRY-E_CTRL_OUT_DQ
• X1:CRY-W_CTRL_OUT_DQ

from 16384 Hz to 32768 Hz in preparation for noise plots that go to 10 kHz. I also added the channels

• X1:CRY-E_REFLDC_OUT_DQ
• X1:CRY-W_REFLDC_OUT_DQ

for logging at the same sampling rate. I further added the following relevant dither channels to be written to disk at 1024 Hz:

• X1:CRY-DITHER_BEAT_OUT_DQ
• X1:CRY-DITHER_E_MON_OUT_DQ
• X1:CRY-DITHER_W_MON_OUT_DQ
• X1:CRY-DITHER_E_I_OUT_DQ
• X1:CRY-DITHER_W_I_OUT_DQ
• X1:CRY-DITHER_E_Q_OUT_DQ
• X1:CRY-DITHER_W_Q_OUT_DQ

The cymac models were restarted to make the change take effect.