40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  PSL  Not logged in ELOG logo
Entry  Tue Mar 8 18:34:06 2016, Antonio, Summary, PMC, PMC preparation 
    Reply  Wed Mar 9 16:18:42 2016, Antonio, Summary, PMC, PMC preparation 
Message ID: 1611     Entry time: Tue Mar 8 18:34:06 2016     Reply to this: 1612
Author: Antonio 
Type: Summary 
Category: PMC 
Subject: PMC preparation 

This morning I sent an email to Evan in order to obtain PMC documentation. 

For now the only documents found is a mechanical drawing E1400332. I am aware of additional 2 documents that he wrote for this design. I also asked for the electronic/servo

instructions as I am not aware if he built/bought parts for the PMC servo.


This morning I have also poked Rich, in order to have advices on what type of epoxy we need to buy for pzt gluing. Not sure about that. I am going to investigate

on what to buy and especially what should be the best procedure for gluing.


We have been collected the materials bought from Evan:

1. Spacers;

2.  Mirrors;

3. PZTs;


Things to buy:

1. O rings;

2. Epoxy for PZT;

3. Screws;


I am considering to use the table in the TCN lab, once we have a functionally lab. All the information about the PMC will be collected in a section on the PSL wiki page.

ELOG V3.1.3-