2017-08-23

• Installed ESD Prototype design by taping it to the older design, we then lowered the mount until it was as close as we could reasonably get it. The new PCB lines up when the top of the new PCB is lined up with the last electrode on the old one. The new PCB was slightly too narrow, the mounting holes are very close to the edge of the PCB, this can easily be corrected in later models.
• Installed sample S1600541 into the single sample apparatus
• Roughing pump on at 12:32
• Turbo pump on at 2:28pm

Link to image1.JPG Link to image2.JPG