40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  Coating Ring-down Measurement Lab elog  Not logged in ELOG logo
Message ID: 411     Entry time: Wed Aug 16 10:04:24 2017
Author: Zach 
Type: Electronics 
Category: Modeling 
Subject: ESD along edge 

2017-08-16

  • I placed created a very narrow ESD placed along the edge of the sample. The thought behind this is that it will not cross over into any other modes that will cancel out the force. However, it does not appear to couple force into enough of the area of the disk to cause a worthwhile improvement, as can be seen in the plot, more modes lost amplitude than gained and some were worse by as much as a factor of 1000.

Attachment 2: overlay15.jpg  33 kB  | Hide | Hide all
overlay15.jpg
ELOG V3.1.3-