Not logged in
Fri Jul 18 17:12:35 2008, Jenne, Update, IOO, Checking out the MC Servo Board
Fri Jul 18 19:15:15 2008, Jenne, Update, IOO, Checking out the MC Servo Board
Fri Jul 18 17:12:35 2008
Reply to this:
Checking out the MC Servo Board
One of the things that Rana thinks that might be causing my MC_F calibration to be off is that the MC Servo Board's filters don't match those on the schematics. Max and I pulled the MC servo board today to check resistor and capacitor values. Alberto needed the Mode Cleaner, so we put the board back before finishing checking values. We will probably pull the board again next week to finish checking the values.
I haven't checked to ensure that the MC still locks, because Yoichi is doing stuff on the PSL table, but I didn't change anything on the board, and hooked all the cables back where they were, so hopefully it's all okay.