I took transfer function and noise measurement of satellite amplifier box's photodiode transimpedance circuit. For the measurement, I created a makeshift connector to convert backside DB25 into DB9 with the 4 channels for PDA input. The output was taken in differential form at the front PD Output port. To feed current to the circuit, I put in 12 kOhm resistors in series at the inputs, so the V/V transfer function measured was multiplied by 12 kOhm to get the transimpedance of the circuit.

Transfer Function Measurement details

• SR785 source out was fed into PDA input pins using a makeshift BNC-DB9-DB25 converter.
• The output from PDOut DB9 port was fed to test switch in D1900068 to separate differential signal.
• This differential signal was fed back to SR785 at input 2 in A-B configuration.
• Measurements are taken with file D1002818_TF.yml and D1002818_TF_LF.yml.
• A measurement of just cables without the DUT is taken as well.
• Commands.txt list all the commands used.
• All data is compiled and plotted in Plotting.ipynb
• D1100117_S2100029_TFandNoiseSpectrum.pdf shows all the transfer functions measured.

Spectrum Measurements

• Two pair of BNC cables were twisted together and clips were added at ends.
• One of the GND was connected to board GND. Rest were left unconnected to avoid ground loops.
• Each pair of signal was connected to PDOutP/N.
• The PDA inputs were shorted together to make zero input current to the board.
• Instrument noise with cables was measured by shorting the clips of the center cores and one of the shields of the two BNC cables together.
• Measurements were taken with file D1002818_SP.yml and D1002818_SP_LF.yml.
• Input referred current noise spectrum was calculated by dividing the output voltage noise spectrum by the measured transfer function.
• D1100117_S2100029_TFandNoiseSpectrum.pdf shows all the output votlage noise spectrum and input referred current noise spectrum measured.

Edit Wed Feb 10 15:14:13 2021 :

THE NOISE MEASUREMENT WAS WRONG HERE. SEE 40m/15799.