40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  TCS elog  Not logged in ELOG logo
Message ID: 240     Entry time: Mon Aug 12 21:15:12 2019
Author: Edita Bytyqi 
Type: Electronics 
Category:  
Subject: Determining heater/reflector focus 

I took images of the heat pattern projected on a piece of paper produced by the semi-circle reflector. I used 108V to drive current throught he heater. I tested the reflector without any coating and then with the dull and shiny sides of Al foil. I wasn't able to test the focal-point cut reflector because I had to glue a screw to it with epoxy which cures overnight. I will do these measurements tomorrow. Figure 2 shows the setup I used to get the data. The shiny side of Al foil is better at IR, so we will use that for the wavefront measurements.

Attachment 1: 20190812_151316.jpg  3.639 MB  Uploaded Mon Aug 12 22:29:21 2019  | Show | Hide all | Show all
Attachment 2: 20190812_151258.jpg  4.062 MB  Uploaded Mon Aug 12 22:29:32 2019  | Hide | Hide all | Show all
20190812_151258.jpg
ELOG V3.1.3-