[Paco, Ian]

paco helped me wire the ETMY 1Y4 rack. We wired the following (copied from Koji's email):

1. Use DB9-DB9 to complete the wiring between
   1. 16bit DAC AI Chassis - End DAC Adapter (4 cables)
   2. End DAC Adapter - HAM-A Coil Driver (2 cables)
   3. AA Chassis - End ADC Adapter (2 cables)
2. Koji already brought two special DB9-DB15 cables (in plastic bags) to the end. They connect the HAM-A coil drivers to the satellite amp. At this time, we skip Low Noise HV Bias Driver.
3. Bring two 30ft DB9 (called #1, aka D2100675-01) cables from the office area to the end. I collected one end and left them there.
4. All the new units have +/-18V DC supply in the back. Find the orange cables behind the 40m vacuum duct around Y-end and connect the units and the DC power strip. Use short cables if possible to save the longer ones.

the cables we used:

I attached pictures below.