|
40m
QIL
Cryo_Lab
CTN
SUS_Lab
TCS_Lab
OMC_Lab
CRIME_Lab
FEA
ENG_Labs
OptContFac
Mariner
WBEEShop
|
| 40m Log |
Not logged in |
 |
|
|
 Thu Feb 18 15:15:12 2021, yehonathan, Update, SUS, OSEM testing for SOSs 
|
 Mon Feb 22 14:06:49 2021, Yehonathan, Update, SUS, OSEM testing for SOSs
| |
Wed Feb 24 10:23:03 2021, Yehonathan, Update, SUS, OSEM testing for SOSs
| |
Wed Mar 3 11:51:07 2021, Yehonathan, Update, SUS, OSEM testing for SOSs
| |
Tue Mar 9 14:30:22 2021, Yehonathan, Update, SUS, OSEM testing for SOSs
| |
Tue Mar 9 15:19:03 2021, Koji, Update, SUS, OSEM testing for SOSs
| |
Tue Mar 9 18:49:28 2021, Yehonathan, Update, SUS, OSEM testing for SOSs
| |
Tue Feb 23 20:55:19 2021, Koji, Update, SUS, OSEM testing for SOSs
| |
Wed Feb 24 10:09:16 2021, yehonathan, Update, SUS, OSEM testing for SOSs
|
|
|
Message ID: 15835
Entry time: Tue Feb 23 20:55:19 2021
In reply to: 15816
Reply to this: 15837
|
| Author: |
Koji |
| Type: |
Update |
| Category: |
SUS |
| Subject: |
OSEM testing for SOSs |
|
|
I can't obtain a consistent view between the existing drawings/photographs and your pin assignment. Please review the pin assignment again to check if yours is correct.
Looking from the back side and the wires are going down, the left bottom pin is "Coil Start" and the upper right adjacent pin is "Coil End". (See attachment)
So in your picture 1 should be the coil start and 4 should be the coil end, but they are not according to your table. |
|
|