40m QIL Cryo_Lab CTN SUS_Lab TCS_Lab OMC_Lab CRIME_Lab FEA ENG_Labs OptContFac Mariner WBEEShop
  40m Log  Not logged in ELOG logo
Entry  Wed Sep 7 18:00:47 2016, Lydia, Update, General, Acromag Progress 
    Reply  Thu Sep 22 20:18:27 2016, Lydia, Update, General, Acromag Progress 
       Reply  Wed Oct 12 18:09:25 2016, Lydia, Update, General, Acromag Progress 
Message ID: 12514     Entry time: Thu Sep 22 20:18:27 2016     In reply to: 12477     Reply to this: 12554
Author: Lydia 
Type: Update 
Category: General 
Subject: Acromag Progress 

We moved the Acromag and its power supply to the X end, where we connected it to the diagnostic output of the NPRO controller. We renamed the channels to be descriptive of the pin outputs as described in the laser manual. We were able to recover readouts similar to those we found with a multimeter. 

We should figure out how to set up the channels on the front end machines: right now they are accessed through a tmux session running on pianosa. Once we are confident in the operation, we will make a box to contain the Acromag and wire connections and move the setup to connect to the PSL controller. 

ELOG V3.1.3-